Maste Slicer V

Masking is necessary to paint the colors of assembled plastic models neatly, but cutting a large amount of masking tape to fill in long and thin lines, complex patterns, and gaps in curves takes a lot of time and effort.
The Master Slicer V is a compact cutter that uses replacement blades (6 mm wide) from commercially available design knives and can cut multiple thin strips of masking tape at the same time with up to five blades. By using the included cutting mat with slider, you can easily cut out large amounts of masking tape without getting it dirty.

Make lots of thin strips of masking tape in one go to fit the areas you need to stick them on!

By simultaneously installing a commercially available 6mm blade replacement blade for design knives (sold separately), you can create multiple strips of tape at once.
The number of blades can be changed up to a maximum of 5, so you can create tapes with a minimum width of 1mm and a maximum width of 4mm.
In addition, if you use two replacement blades, you can cut out curved masking tape and plastic sheets. It is also compatible with holographic sheets and colored cutting sheets, so you can enjoy decoration without painting.

*Please use masking tape with a width of 10 mm or more.
*The length of each strip is approximately 8 cm at maximum.
*This product is only compatible with masking tape and plastic sheets with a thickness of 0.3 mm or less.

Easily create detailed masking tape!

By using the included cutting mat with slider to cut the tape vertically, you can make many small masking tapes to suit your needs at once. You can create masking tape as small as 1mm x 1mm, which allows you to make precise masking such as filling in gaps in curved masking and digital camouflage.

A dedicated thin cutter!

The cutter is designed with a grip that fits in the palm of your hand, making it easy to hold and apply pressure to the cutting edge. The tip is specially designed so that when the cutter is pressed against the floor, it can neatly cut the masking tape at the optimal angle.

The blades are fixed at a fixed distance by the metal blades attached to them, so the blade spacing is less likely to fluctuate and you can cut cleanly at a consistent width. After use, you can tighten the special protective cap and store it safely.

A special cutting mat that increases work efficiency!

The size is specialized for the area to cut out the masking tape, so it is compact and does not take up much space. To make fine masking tape, move the vertical cutting slider horizontally while cutting the thin masking tape vertically. Once the masking tape is cut, simply remove it from the cutting mat and you can immediately start the next masking job. There are a total of four places to cut the masking tape, including the top and bottom of the front and back, so if the area to be cut becomes damaged, you can use it for a long time by flipping the cutting mat upside down or over.